Products
Products
LS16C/10_LT32C/10 LISN artificial power network Return
Product overview
It complies with the CISPR 16-1-2 international standard conducted electromagnetic interference measurement requirements, according to the electromagnetic interference international European standard and product standard measurement requirements, the measurement range is from 9KHz to 30MHz, used for DC-63Hz power measurement, manual and program control are both possible.

It complies with the CISPR 16-1-2 international standard conducted electromagnetic interference measurement requirements, according to the electromagnetic interference international European standard and product standard measurement requirements, the measurement range is from 9KHz to 30MHz, used for DC-63Hz power measurement, manual and program control are both possible.

  Multiphase line impedance stabilized V-line network (50uH+5Ω)//50Ω, standard with artificial hand and protective grounding simulation network. Artificial power network can also be used for DC conducted interference measurement.

  Air-core coil design is adopted to avoid the saturation effect caused by high current, and the coarse guide coil ensures continuous large load current capability. Based on this design structure, the artificial power supply network can be easily used for electromagnetic interference test in high power consumption environment.

Test application:

  The front panel of the artificial power network has function buttons corresponding to the phase line. You can manually select the phase line (L1, N or L1, L2, L3, N) that needs to be tested for conduction, or through the AFJ receiver or click analyzer The control software to automatically execute:

  ◆ AFJ FFT 3010 & 3030 series receivers

  ◆ AFJ DDA55 Click Analyzer

  According to the requirements of CISPR16-1-2, the artificial hand can provide an analog resistance of 510Ω+220pF through the special interface on the front panel of the artificial power network.

  The object under test generally has sufficient ground protection conduction impedance (close to the 1/4 wave wavelength). In the case of poor conductivity, the built-in artificial ground protection will be used to perform the test.

  When the DDA55 click analyzer is used to perform the test, there is a built-in ammeter, which can perform switching operation and EUT absorption current measurement in accordance with the requirements of CISPR14-1.

  LS 16C/10 and LT 32/10 have built-in pulse limiters with 10dB attenuation.



Meet the standards:
application area:
technical parameter:


Product number

LS16C/10

10 ◆ 16A single phase

LT32C/10

10 ◆ 32A three-phase

Technical specifications

 

LS16C/10

LT32C/10

design

Fully comply with CISPR 16-1-2 standard

Frequency Range

9kHz-30MHz

impedance

(50µH+5 Ω) // 50Ω

Rated voltage

230Vac rms

230Vac rms/450Vac rms

Phase

1+N

3+N

Rated current

× 16A

× 32A

Maximum allowable frequency

Power supply DC to 63Hz

Output impedance

50 Ω

Connector

BNC female end

Artificial hand

510Ω+220pF

Protected area

50µH// 50 Ω

Built-in limiter and attenuator

parts:
Video playback:

Copyright:Shanghai Lioncel Electromagnetic Technology Co., Ltd (2020)

沪ICP备12035591号